May 24th

Today was an OK day. Only had one delivery today. Loaded a 3320 tractor with bucket and grapple, a six way push blade, a  frontier 2060 rotary cutter, a 655 tiller and a post hole auger on the two ton roll back truck. The truck was crowded. Had to put the tiller and post hole auger on the back of the truck because they had to slide off since they were not mounted to the tractor. After I was finished with the delivery, I managed to work on the two 3320's  with the loader installation. Finished the loader install and then had to put wheel weights on the rear wheels. That was a fiasco in itself. Could not put the weights on the outside of the wheel where the installation would be easy because the valve stem was in the way. Had to remove the wheel from the tractor and bolt them to the inside of the wheel. When I was attempting to remount the wheel on the tractor, I found that the wheel weight opening in the center would not go over the hub on the tractor. That meant swapping wheels between sides. If it wasn't one thing, it was something else. I guess that's the life of an AG technician.